top of page

Instructions for the Invisible Mic Mount

Step 2. Installing the RODE Wireless GO (SC2 cable - coiled) 

or

Connect the cable to the RODE Wireless GO, then attach to the Invisible Mic Mount

 

Secure the cable by pushing it over the slots and connect to the camera. 

   Required Parts

1. Insta360 ONE R with Mounting Bracket/

                 ONE R with Boosted Battery Base/

                 ONE RS with Mounting Bracket

2. 1/4" Camera Mount Adapter* and 1/4" Thumb Screw*

3. Invisible Mic Mount

4. Selfie Stick

5. Insta360 ONE R/RS Mic Adapter 

6. RODE Wireless GO/GO II

​

*Included with the Insta360 ONE R/RS

​

Please note: SC2 (coiled) cable is required for use with ONE RS.​

Step 1. Installing the Invisible Mic Mount

Place 1/4” camera mount adapter onto the Invisible Mic Mount (in the correct position for the camera port), insert the selfie stick and tighten. 

Step 2. Installing the RODE Wireless GO II (SC5 cable)

Connect the cable to the RODE Wireless GO II, then attach to the Invisible Mic Mount.

 

Insert the cable into the slots to secure in position and connect to the camera. 

 

Please note: SC2 cable (coiled) is required for use with the ONE RS.

Additional Extras (Included) - Optional

For SC2 cables that are slightly longer, stretched or used overtime, we have included some additional extras to help secure your cable. 

Installing - Cable Ties

Step 1. Place the cable ties into the slots (right to left).

Step 2. Secure cable ties on the left side. 

Step 3. Cut the excess off the cable ties.

 

(Tip: We found nail clippers are perfect for a close cut and prevents exposed sharp edges)

Removing - Cable Ties

When removing the cable ties we recommend cutting the section of the cable tie furthest from the cable (as shown) to reduce the risk of damaging the cable or mount.

​

Note: If you require additional cable ties, we use 2.5mm black nylon cable ties. 

Installing - Band (Latex Free)

Attach the RODE Wireless GO to the Invisible Mic Mount and secure the cable in position, without connecting to the camera.

Step 1. Place the band over the cable and mount, then adjust to find the best position for your cable.

Step 2. Now, connect the cable to the camera. 

bottom of page